ironhead

one step at a time. the motor is 98% done pretty much all new. new rods, rod bearings, piston pin races, pinion shaft, pinion race, new rollers, cam bearings, blah blah blah long story short all new bearings, new pistons/rings. bored .050 over  new clutch, clutch springs, everything you can think of miced to factory specs...kick only magneto bike (i like a challenge) ,should be a solid motor (but its still an ironhead)  next is deciding what i want to do with the frame.

half done

with the outline.... Adam over at little blues said he wanted to do a backpiece so i said fuck yeah. we tried to do the entire outline in one setting, but it was just a try..... after 4 hours i gave in and he was over it too. were going to try for the other half in a few weeks.